Find help with gutters and downpipes around Pakenham.

How downpipes and stormwater work

How roof water travels from gutters to the street drain on Pakenham 3810 homes.

Every litre of rain on a Pakenham 3810 roof has to go somewhere. Gutters collect it, downpipes carry it down, and underground pipes take it to the property’s legal point of discharge, usually the street kerb or an easement drain. Roof drainage design is covered by AS/NZS 3500.3. This guide explains each part and what goes wrong.

The path of roof water

A typical suburban system has five parts:

  1. Gutters along the roof edge, falling toward outlets
  2. Outlets and rain heads where gutters drain into downpipes
  3. Downpipes down the walls, fixed with brackets
  4. Stormwater risers and underground pipes taking water from each downpipe to a main line
  5. The legal point of discharge, where the property’s stormwater leaves into the council system

Rainwater tanks, surface pits in paving, and sometimes a detention or rain garden can be part of the system as well.

The legal point of discharge is the place where the council allows your property’s stormwater to leave your land. For most suburban lots in Pakenham, Officer and Beaconsfield, it is a kerb outlet in the street or a pit in a drainage easement at the rear. Rural properties may have different arrangements.

Cardinia Shire Council can tell you your property’s legal point of discharge. For properties in the part of Beaconsfield within the City of Casey, contact that council. When you add downpipes, extend the house, build a shed or pave a large area, the new drainage must connect to this point.

Stormwater must not discharge into the sewer, onto a neighbour’s land or against your own house. It must not be connected to the sewer, and sewage must not go into stormwater.

Gutters and downpipes work as a system

A gutter’s capacity depends on its size, its fall and how far water must travel to an outlet. A downpipe’s capacity depends on its size and the outlet design. The number and position of downpipes determine how much roof area each one drains. A licensed plumber sizes all of these together for the roof area and the local rainfall intensity.

Common design problems include:

  • Long gutter runs with a single downpipe at one end
  • Large roof sections with too few downpipes
  • Upper roofs draining onto lower roofs through spreaders without the lower system being upsized
  • Valleys concentrating water onto one short section of gutter
  • Box gutters without overflow provisions

These show up as overflow in heavy rain, even when gutters are clean. The overflow and leak investigation page explains how providers trace them.

Underground stormwater pipes

Underground pipes collect water from each downpipe and run to the point of discharge. On older homes they are often earthenware with mortar joints. On newer homes they are usually PVC with solvent-welded joints. Pipes need enough fall to flow and must be laid to avoid sagging.

Pipe issue Common cause Effect
Root intrusion Trees near old joints Blockage, overflow at downpipes
Cracked or broken pipe Soil movement, age, vehicle loads Water leaking into soil near the house
Displaced joint Reactive clay movement Partial blockage, leaks
Silt build-up Debris from gutters, little fall Slow drainage, blockage
Disconnected riser Landscaping, impact Water pouring onto the ground

A camera inspection shows the inside of the pipe and pinpoints problems. The stormwater drain blockages page covers clearing and repair options.

Why water near the house matters

On reactive clay soils common around Pakenham, keeping soil moisture even around a house helps limit footing movement. A downpipe discharging onto the ground, a broken pipe leaking under a garden bed or paving that falls toward the walls creates a wet patch. Clay there swells while other areas stay drier. The uneven movement can show as cracks in brick walls, sticking doors and gaps at cornices.

Water against brick walls also feeds salt damp and efflorescence, and water pooling under timber floors can cause rot and attract termites. Getting roof water into the stormwater system and away from the house is one of the simplest ways to protect a building.

Surface water and paving

Paved areas, driveways and paths collect rain too. They should fall away from the house toward pits, strip drains or the garden, not toward walls. Surface pits connect to the stormwater system and need grates kept clear of leaves. When new paving or a patio is added, plan the drainage at the same time.

Garden beds against walls should sit below the damp-proof course and weep holes in brick walls, so that water in the soil does not bypass them.

Rainwater tanks in the system

Where a tank is installed, some downpipes feed it before excess water overflows to stormwater. The tank’s overflow must connect to the stormwater system or another approved point. A blocked or undersized tank overflow can make downpipes back up during heavy rain. The rainwater tank connections page explains wet and dry systems, first flush devices and overflows.

Who can work on the system?

Changing pipework, gutters or downpipes is regulated plumbing in Victoria, and many such jobs require a plumber holding the right licence class plus a compliance certificate once finished. The Building and Plumbing Commission, successor to the Victorian Building Authority from 1 July 2026, runs a searchable register so owners can confirm a practitioner before work starts.

Owners can do simple maintenance such as clearing leaves from gutters and downpipe outlets. Changing pipework, adding downpipes and connecting to stormwater should be left to a licensed plumber.

Building, extending and adding sheds

When you extend a house, add a carport, build a shed or add a verandah, the new roof area needs gutters and downpipes connected to stormwater. Simply letting a new shed’s downpipe run onto the lawn is not an approved solution. Building permits for many structures include stormwater requirements. Check with your building surveyor and plumber how the new roof will drain.

On larger developments, councils may require on-site detention to slow stormwater leaving the property. Cardinia Shire Council can advise whether this applies.

Simple checks owners can do

  1. Watch the system during heavy rain from a safe, covered spot
  2. Check that every downpipe connects into a riser at ground level
  3. Look for water pooling at the base of downpipes or along pipe routes
  4. Check surface pit grates and kerb outlets for leaves and soil
  5. Note any gurgling or bubbling at risers in rain
  6. Keep gutters clean, which keeps debris out of pipes

The downpipe repairs page covers common downpipe faults, and the gutter cleaning page explains cleaning.

Low-lying and hillside properties

Low-lying properties toward Koo Wee Rup and the former swamp land can drain slowly when the ground is saturated. Hillside properties in Pakenham Upper and Beaconsfield Upper send runoff downhill, and stormwater may need to cross easements to reach a discharge point. In both cases, ask the council and a plumber about the approved arrangement before changing drainage. The Pakenham Upper area page has notes on hillside drainage.

Downpipe and stormwater problems after extensions

Extensions are a common time for drainage problems to start. New roof areas are added, sometimes draining into existing gutters that were sized for a smaller roof. Existing downpipes are moved or removed to make way for the new walls. Underground pipes are cut during excavation and not always reconnected properly. Paving around the extension may slope toward the house.

If you have had an extension built and now see overflow, pooling or damp near the junction between old and new, ask the builder first, since it may be a defect. If the builder’s responsibility has ended, a plumber can trace the system with a camera and dye testing to find where water is going.

Dye and flow testing

Plumbers sometimes use water and dye to trace how a system is connected. Running water into a gutter or downpipe and watching where it appears, at a kerb outlet, a pit or a neighbouring connection, confirms which pipes connect where. Coloured dye makes the flow easier to see. This is useful on older properties where nobody knows how the stormwater was laid, and when checking that a downpipe is not wrongly connected to the sewer.

Stormwater and the sewer

Stormwater and sewer are separate systems. Stormwater connected to the sewer overloads sewer pipes during storms and can cause sewage overflows. Sewer pipes connected to stormwater send untreated waste to creeks and Western Port. Both are illegal connections. On older properties, illegal connections are sometimes found during renovations or inspections. If a plumber finds one, they will explain how to correct it, and the water corporation may also be involved. In the Pakenham area, the local water corporation for sewer services is South East Water.

Planting near pipes

Tree roots seek out water, and cracked stormwater pipes are an easy source. When planting new trees, keep them well away from stormwater lines and choose species with less aggressive roots near pipes. If you do not know where your pipes run, a plumber can locate them with a camera and locator before you plant. Moving a tree after its roots have entered a pipe is far harder than planting it in the right spot to begin with.

Roofs that drain onto neighbouring land

On some small lots and boundary walls, roof water from one house can end up on the neighbour’s land, either because a gutter overflows across the boundary or because a downpipe discharges near it. This is a common source of disputes. Roof water must be collected and taken to your own property’s approved discharge point. If a neighbour’s roof water is affecting your property, talk to them first. If that does not resolve it, Cardinia Shire Council can explain the rules, and Dispute Settlement Centre of Victoria offers free mediation for neighbour disputes.

Records worth keeping after stormwater work

After any stormwater repair, keep the camera footage or screenshots, a sketch of where pipes run and how deep they are, the compliance certificate if one was issued and the invoice describing the work. These records help future plumbers, landscapers and buyers, and save paying for the same investigation twice.

Ask a plumber

If you are unsure how your stormwater system works, or water is pooling where it should not, describe it on the stormwater enquiry form. Include photos of downpipes, risers and any pooling, and video during rain if possible. We pass it to a maximum of three independent plumbers nearby, and any of them may call to arrange a look and a price. This site belongs to Yes Right Pty Ltd, a referral service that does no plumbing itself.

Send an enquiry